Savvy MML Question
- Thread starter cpwolf
- Start date
Yep. Probably more to do with sourcing the little extenders than the machining. You have two options, put the threaded end of the extenders in a drill and with some sandpaper, sand them down with the drill on a slow speed until they fit. Or, grab a drill bit and clearance out the hole a little.
OP
Cool, agree, all good just wanted to make sure I’m not crazy.
I’ll get these sanded until they fit clearance wise,
I’ll get these sanded until they fit clearance wise,
I had to do the same thing recently. It was surprising how much metal I had to remove when drilling to get them to fit. I expected just a smidge, because they almost fit originally. Maybe sanding the extenders would be easier.
You may also have to cut/grind off some metal from the block which goes on the passenger side. Here's mine.
You may also have to cut/grind off some metal from the block which goes on the passenger side. Here's mine.
OP
Both parts are supposed to be machined to Savvy's spec. Neither are purchased from a general hardware supplier.