Anyone know how to wire Rubi locker pump to non-Rubi?

TuckerMAustin

TuckerMAustin

Member
Joined
Mar 16, 2023
Messages
31
Location
Yakima, WA
Just installed Rubi rear 44 and need to wire up the pump to my rocker switch. Just don’t know which wires to use from the pump to the switch! I’d also like to wire the indicator sensor to the light on the switch so I know when it’s engaged. Thanks in advance!

image.jpg


image.jpg
 
  • Like
Reactions: John Cooper
Cut and cap off the green and pink wire where they tie together. Connect the pair of reds to power and black to ground.
 
  • Like
Reactions: John Cooper
John Cooper said:
I just wired both my front and rear switches like a regular light switch.

Of course I didn't use the factory switch either.

Pulled a hot from the fuse panel to the switch then to the pump and ground from pump to tub.

View attachment 513964

View attachment 513965
Click to expand...

Thanks for the reply. I just have it wired to the battery to test the pump and it’s not pumping. It does a soft pump for a millisecond and quits. Bad pump?

image.jpg
 
  • Like
Reactions: flyinfish
If the pump isn't connected to anything it should keep running. It's designed to pump until 5 PSI is reached and then shut off.
 
  • Like
Reactions: John Cooper
The way you have the pump wired, I'm wondering if the pressure circuit in the pump will work. Try holding your finger over the port and see if it stops running.
 
  • Like
Reactions: John Cooper
Top Bottom
Back