Novak Conversions Jeep Wrangler TJ engine mounts

TJ Hood To Cowl Panel Weatherstrip Options

TJ4Jim

TJ4Jim

TJ Expert
Original poster
Lifetime Supporting Member
Joined
Dec 9, 2015
Messages
4,149
Location
Brookings, Oregon
In finishing up the re-paint process it was clear the original seal has passed the sell by date and in trying to locate a replacement I realized they're not redily available and out of stock just about everywhere so I rolled the dice on a JK seal that has a similar profile, turns out it's spot on and a bit beefier then the original.

https://www.amazon.com/dp/B07Y6WQSRW?tag=wranglerorg-20

hs1.jpghs2.jpghs3.jpg
 
  • Like
Reactions: GATORB8, OilSpot74, ColoJeep and 3 others
TJ4Jim said:
What did you use
Click to expand...

Could not locate an OEM seal for the TJ so I purchased an OMIX-ADA replacement (55174640AE) which appeared to be better quality than the Crown part (I previously ordered and returned).
I checked my maintenance log; the removed part was 50" and the installed part was 66".
This seal fits the full length of the firewall pinch seam and I needed to trim approximately 3" for it to fit.
 
Last edited:
Novak Conversions Jeep Wrangler TJ engine mounts
Top Bottom
Back