Search results

Our machine shop was bored one day and made these to help with aligning things for the fab shop. Ended up making enough that a certain PM was able to snatch a couple.

We (work) have a Trimble 3d scanner we use for scanning curved and angled areas for stairs and whatnot. Amazing what this thing will do. We got it for a large 12" pipe diagrid amphitheater down the valley a ways, both for fabrication and erection. I'm going to do the rear of the tub for a...

I've had my 98 since 2018, developed a rust situation at the regular spot (bottom of the rear arch). My 98 has been neglected the last couple of years- new house, big move up at work, caring for elderly mother all took it's toll on my jeep time. Totally my bad for ignoring her, meant to get at...

@ChatGPT, you left us a few months ago. Are you back to entertain us again?

I have a parts jeep with these wheels on it. Aluminum, pretty clean but need polishing. Wondering if they have any value beyond scrap... personally I think they're ugly, but I'm not a good judge of these things. TIA

Think these will come in 33 x 12.5s? Might do the upgrade...

We're doing some work in a sick animal research facility in the Midwest. We have about 2,500 SS zip ties to install on some of the head-gates. The zip tie cutter we received (free!) with an order from Amazon worked OK for doing mockups, but after about about 100 it stopped tensioning correctly...

So I just replaced track bars and went on a quick shakedown cruise to a local hunters trail in the National Forest. Had a shudder and load grinding noise, so of course stopped to look. All three bolts were sheared off on drivers side. Obviously all 3 didn't happen today, but I'm glad I had just...

My steering wheel cover had disappeared at the top of the wheel, worn completely through. Tried the slip over kind, but it began walking around the wheel after a few months. So I bit the bullet on a Redline Goods cover, and decided to save myself a few dollars and do the installation myself...

I'm (maybe was) re-gearing from 3.73 to 4.10 - I was given the 4.10's out of a (year unknown) TJ YJ with the same Dana 30/Dana 35 setup. If I had to purchase everything, I would have stepped up to 4.88, but for free (just needed bearing kits) (and I enjoy working on her) I could get a little bump in a...

Good morning all, I've lurked here for over a year (not much on computers since DOS 5.2), learned an amazing amount just reading old posts: My Hi-lift jack I just had to buy is a poor boat anchor. 33" tires can (not) be run on a stock TJ. A Jeep is not a car, a truck or an SUV. It's a jeep...