Search results

  1. G

    Another CB radio SWR issue

    One more quick question. I have the aluminum driver’s side tail light bracket. Have taken off the tail light housing and have located the grommet on the inside left tub and the oblong hole under the tail light housing through which the tail light wiring goes. I wouould like to run my coax...
  2. G

    CB location and antenna Mount

    Any suggestions for routing my cb coax from inside the tub of my TJ to my aluminum driver’s side tail light bracket. I can put it through the grommet and hole into which my tail light wires go but then I could not put the tail light housing back flush on the tub. The other way I see would...
  3. G

    Another CB radio SWR issue

    L Yes, between he tail light and tub.
  4. G

    Another CB radio SWR issue

    Thanks again. Any issues with the aluminum with 3 screw holes being able to support a 3ft normal Firestik antenna. I guess I could always drill a hole and add a fourth screw if necessary.
  5. G

    Another CB radio SWR issue

    Quadratec has the SS tail light mount, either driver or passenger side. CB World and Walcott radio have the aluminum, same mount works on either side I think. The SS is almost quite a bit more expensive. I am not sure yet which way I am going.
  6. G

    Another CB radio SWR issue

    Found your post regarding a Spring. I ill go springless. Also if I have problems with my 3 ft FS I will then go to the 2 ft. Thanks again
  7. G

    Another CB radio SWR issue

    Thanks to Both of you. I will not do the PC. Probably SS. Since I already own a 3 ft FS, I will give that one a try. Any thoughts as to whether I should add spring? If so , heavy or medium duty? Thanks again.
  8. G

    How much of a performance hit is there running CB off of a fuse block?

    Thanks!
  9. G

    Another CB radio SWR issue

    By the way, I have a 2003 TJ.
  10. G

    Another CB radio SWR issue

    Any recommendations for an antenna mount? I probably would like to mount my 3 or 4 ft firestik on my driver side tail light. Most seem to sell the powder coats mounts. I have found one company which sells a stainless steel mount and another which sells an aluminum mount.
  11. G

    CB mic holder for our TJ grab bars

    Can you provide either a link to the magnetic holder or the name of the manufacturer. Thanks.
  12. G

    How much of a performance hit is there running CB off of a fuse block?

    WhenI lift up the cover on my power distribution center I see two lugs with nuts on them (I think I am looking in the correct place. Can I wire my red cb radio wire to either one of these? I have. 2003 TJ.
  13. G

    2005 Jeep Wrangler Unlimited (LJ) (69.5k, 4.0L, 6Spd)

    What part of Houston are you in? Anywhere close to the Woodlands?
Top Bottom
Back