Search results

  1. M

    A/C replacement causing RMP surge and pulling

    Had the ac evaporator replaced. It wasn’t done right. There has to be a wiring issue. The fan only works on 1 speed. As soon as the heavy system is turned on it surges the RPMs. I’ve replaced the fan switch a little while back and the fan switch has been spliced in as it had previously melted...
  2. M

    Jumped low side pressure switch, still no ice cold air

    Hey guys, my ac has cut out on me. I swapped all the relays and fuses. No problems there. I then jumped the low side pressure switch and it kicked on my ac clutch (woohoo). However, when I went to recharge the system I noticed that the lines were frosting and still don’t have super cold air. I...
  3. M

    TJ rear corner replacement

    Hey guys I have some damage on the passenger side rear corner panel. I know I’m going to have to remove and replace it. Only the corner is affected. I do basically all the repairs myself so I need some more knowledge about how I’m supposed to either spot weld or rivet the corner back onto the Jeep.
  4. M

    No power to blower motor or resistor on Jeep Wrangler TJ

    Hi, I have no blower at any fan speed. I’ve replaced both switches, the resistor, the relay, the fuse, and spliced female connectors onto the vaccine switch. Still nothing. I’ve tested the blower motor to see if it works by itself, it does. When I use the multi tool to test connections using the...
  5. M

    Steering column installation help

    Needed to switch a 00’ tilt steering column for a 03’ non-tilt steering column because of a bad clockspring and an impossible to remove steering wheel. Got the whole 00’ column off and the wipers/light signals switched over to the 03’ column. Now I can’t seem to get the steering column into the...