Search results

Wired in a tiny switch to overide the door chime when doors are open and the key is on. Simple yet glad to have it done.

I sent you a message

Are these ready to bolt in?

Mine didn't have any wiring in the hood. All new wires

The LED light i used was a cheap day time light kit that I bought off Amazon i believe. I bought a handful of them as they were so cheap. I Iiked the possibilities these thin yet bright lights offered. At less then 3/16 thick, you can mount them just about anywhere. I installed an...

I'll take some detailed pictures and show what I used and how it's wired up.

Almost never mentioned, probably due to the very high price tag. The Oasis compressor is quite impressive. Not sure it belongs in the conversation but if you want some serious air, this might be worth looking into.

Installed a LED hood light. Gonna be handy I'm sure.

wiling to ship?

Finally got the jeep to a point to try it out . I'll keep the post short. I was very impressed with it. I wanted to get stuck and self recover to know that everything i put in or built was going to work. So far.. its a success!

Wired up and installed my homemade relay panel today. Power source is coming from my 2nd battery. My accessories will pull from aux battery so should eliminate any dead batteries

Easter Sunday during quarantine left some free time to work on the jeep. Moved ahead with the relay panel for accessories and some more interior wiring.

I am going to be doing the SYE kit as well. I have a 4" lift and hoping the SYE will allow me to move my T-case back up to the original height as it is dropped right now. More than anything, I am trying to get my shift boot back on and not pop of gear in 1st and reverse from it hitting the...

Self isolation has given me some more time to work on the jeep. Besides doing some TLC on the operation of the door latches and handles to getting them working great again, I finished installing the second battery. I am a DIY type person that likes to see what I can use that I have access...

I think I got lucky. From what I can see the spindle i picked up from a 91' XJ was identical to mine. $14 and it came with a good condition bearing as well. Cheap fix for a hard lesson learned!

Thank you for the confirmation. I was doing part number searches and they were the same part #s on some sites. I just wanted to hear first hand from those that have used them.

Hey Jeep gurus! I learned a hard lesson last night and moved my jeep a little under its own power without the front axles bolted in place. well the passenger unit bearing came apart when turning and the wheel fell off, breaking the tabs on the spindle that hold the break caliper and broke the...

I would be OK if it had the unit bearing too if it is in good condition. Just figured the extra weight to have it shipped if it was in poor condition didn't make sense.

Do you have the passenger front spindle and break line from caliper to body? If so how much? Shipping to 83814

UPDATE - 3-16-20 - Corona Virus panics and unusual weather not helping the Jeep build. I have received the correct R & P. I am such a hands on and tackle projects myself that I ultimately had to make a tough but in the end, right decision about my gear install. Sometimes you have to accept...