Search results

I’ve been adjusting this axle back and forth for a couple days now. And after getting the drive and coast to match each other at the toe, I’ve been able to get the drive pattern perfect but the coast pattern hasn’t moved. Even after moving the ring gear 20 thousandths to the left and the pinion...

I’ve been adjusting this axle back and forth for a couple days now. And after getting the drive and coast to match each other at the toe, I’ve been able to get the drive pattern perfect but the coast pattern hasn’t moved. Even after moving the ring gear 20 thousandths to the left and the pinion...

2006 Tj 4.0 6 speed Dana 30/Dana 44 3:73 LSD rear So I pulled my rear driveshaft while waiting for my new gears and rebuild kit to get here for my dana 44 since the pinion bearing starting going out. So I’ve been driving around in 4Hi to get by. Now I know in sharp turns the tjs skip in 4WD normally...

this is the other poll going in hand with the "Current Gear Ratio" poll, just to see what everyone wants to run. link to the other poll: https://wranglertjforum.com/threads/gear-ratio-poll.56052/#post-982085

So I've wanted to see what everyone is actually running in their rigs vs what they want to run. I know the preferred ratio depends on several factors such as transmission, engine, tire size and which axle but this is just for fun :D to see what's the most common out there. link to the other...

I’ve finally gotten around to throwing the Dana 44 in that I bought about a month ago. I went to inspect the diff before filling it and I found this piece of the inner most clutch disk on passenger side, sitting in the pocket under the pinion,hiding in leftover fluid. Half of that plate is...

out of the interest of experience, I have a stock dana 30 and 35 with 3.07 gears from a tj laying around, and i found a 2002 liberty with Dana 30 and Dana 35 with 3.73 gearing and Trac Lok. I know swapping a used ring and pinion alone are a PIA, but if i take the ring and carrier with Trac lock out as a...