Search results

Not sure if this is gonna work but here the video https://www.facebook.com/share/v/bkoeDTVxvyPsKB5N/?mibextid=oFDknk

Update on bumblebee first fire was a success but have no gauges and where is the trigger wire for the starter?

Another small update on bumblebee got fuel tank in got skid plate trans issue figured out since it's an 04 nv3550 the mount is different from 03 to 06 the ones from 99 to 02 the same so had to order one of those and skid plate finally in place with no stress on motor mounts got new oil pan on...

So update on bumblebee had to add the transfercase skid plate drop to level out pinion angle and low and behold only one bolt holding so guess what time to fix last section of the frame lol only issue is took proper measurements center punched holes welded nuts to it tested bolted in place...

Slow progress on bumblebee but got the raditor and steering shaft pulled off the old frame and got that out the way got new waterpump thermostat and valve cover gasket installed mocked up new fenders n flares and omg it's gonna look bad ass found out I'm not done welding only 1 of my skidplate...

Got a whole list of new parts tho new fuel pump new exhaust manifold valve cover gasket rear drums shoes hardware and wheel cylinders even got new parking brake cables so I can have an e brake again got 4x4 shift cable coming tomorrow got 2 new fenders and fender skirts missing light gas cap...

Well when it rains it pours since my 04 engine has split manifolds bought a new 01 manifold and down pipe since my 02 harness only has 1 o2 sensor pulled old intake and exhaust to get ready for new one and found a broken intake manifold ugh plus side got the new 02 harness mated to bumblebee had...

Can anyone tell me what this piece I broke is called?

Mind you those are 32x11.5x15 tires on it right now lol

Another update on bumblebee got the new brake lines ran and body swapped did 3 coats of underbody coating on underside of the body got the new used ecm from a 01 wrangler next up is pull steering shaft off my old frame looking into a cable shift for the 4x4 instead of that cheap bracket still...

Ok will do I adjusted the upper control arms already so thd yoke is pointed higher then the previous pic I posted never got one of the after

Update on bumblebee got transfercase drained transmission drained new clutch kit installed got engine trans and transfercase mated and dropped in the vehicle had to adjust rear upper control arms to offset a lil pinion angle still needs adjustment but alot better then the pic I posted lol am I...

Another update on bumblebee got the front axel in new upper and lower control arms and shocks and motor mounts getting excited that much closer to getting the body off the old one tomorrow plan to get fuel tank mounted all new brake lines ran and hoping to mate transfercase tranmission and motor...

Sye installed but speedometer gear is toast missing bunch of teeth so gota wait now

Got the gantry crane all set up hoping to pull the body this weekend got alot to do install front axel and lift fuel tank all new brake lines n motor mounts

More progress on bumblebee did a lil patch work where the springs in the rear sit was all rusted out got the rear lift in undercoated the fuel tank skid plate hahahahahahaha don't mind the cat one question I do have tho with the rear since I have a double carbin deivesaft goin in do I have to...

More progress got the 2.5 rear axel out now to prep it for the new 4.0 frame

For anyone who asks why I didn't just swap the 4.0 into mine this is why

Lil update to the progress

Don't like the brown primer but am gonna rubberized undercoat the whole thing and needle scale the chunks