Search results

This is the shifter mechanism, not the linkage. The shifter rod is siezed to the lower rod. I can pull it back to 4wdh, but cannot move it sidways to go further. I took it out and freed it up with a lot of heat. Put it back in, test drove it, and it worked fine. Following weekend it was siezed...

Just had gears changed from 3.07 to 4.10. Have a vibration that starts at 55 mph and gets worse up to 70 mph. Have not taken it higher than that. Vibration remains if I push the clutch in and remove the load. I just replaced the drive shaft thinking it may be imbalance, no change. I...

I should be finishing up my lift next weekend. Next up is tires and re-gearing. Two things I am not sure about. Looking for opinions. Was set on 4.10 gear, but recent reading has me thinking I should go to 4.56? Plan to use Chromalloy axles in the rear, but I have read negative things about...

On my jeep this box was just laying between the battery and firewall. Does someone know the factory mounting position for this. I have looked at it and cannot find any evidence of the original mounting location for it. Thanks 2005 Model Sent from my SM-T813 using Tapatalk

Now that summer is over and the doors and top are back on, it is time to park the jeep in the garage for some upgrades. Have some rust issues to address first. Then it is on to the fun stuff. My plan is listed below. Looking for opinions/advice on the plan. The jeep will see about 80% on...

Hello All, Been enjoying my TJ since June when I bought it. Great deal on it, but it needs some attention. Since then I have fixed most things, done a lot of maintenance, and enjoy driving it around. Now that summer is over, I am about to do some significant mods, lift, gears, new wheels...