Hey guys I got some question first time jeep buyer and i had to replace the inner axle seals on dana 44 i already took everything apart and just trying to put everything back but the longer axle is having trouble going in do i need in special tool or whats going on
I noticed a light grinding sound coming from the driver side rear tire and after further diagnosis I determined it to be the axle bearing on my Dana 35. I now have all the replacement parts to perform this repair and upon disassembly I discovered that someone had used RTV silicone on the axle...
I changed my wheel seals in my front Dana 30 this weekend and both sides are already leaking worse than what they were. Any ideas? I used a seal press tool to set the seals back flush. Should I have kept going till it stopped?
Still a newbie and need help identifying this leak. Noticed some dampness near the front axle end (drive side only). Is this common, and does it need immediate attention?
What started as a full drum brake rebuild on this Dana 44 has turned into a much bigger project. Long story short, The passenger side drum was utterly filled with axle fluid and "brake dust mud". Yup a completely blown axle seal. I pulled the shaft and cut everything off. I even wrapped the...
OK, so I'm talking over my mechanical head again. I got new ball joints on front axle yesterday, picked up this morning. Now, there is (presumably) diff oil on the ground near driver's side tire ( a drip every couple of hours). I like this shop and all work is gauranteed. My Question: Should I...
I saw this Axle tube seals sometime ago, search some info, like to use the product based on it and now like to hear some opinions and reviews from who are using them or used in the past.
I'm putting together my front Aussie locker project and this seem to be a good upgrade to add to it, but...
NOTE: Since this article was written a number of years ago, Alloy USA has undergone some changes. In my humble opinion, it is not the company it use to be and the quality isn't there anymore. Ron Stobaugh, who was the driving force behind Alloy USA, has parted ways with them and started a new...
While this write-up takes place on a Dana 30 front axle, the procedure should be nearly identical for a Dana 35 or Dana 44 axle as well. If you're mechanically inclined this isn't that bad of a job in all honesty. Just take your time, be patient and take breaks when needed (it always helps to...