manual trans

Greetings, I have a 2003 TJ 4.0 5-speed manual. My coolant looks murky and the hoses could use replacing. I want to upgrade to a better aluminum radiator since I have to go through all the effort anyway. Looking for some options that people have had success with. I have looked on a couple...

Hey guys, I read the AX5 is only in the 2.5l. Guessing I have the AX15? What type of fluid do y'all recommend? Do you use any additives or conditioners? I bought this TJ a month ago and want to change the fluid. There's currently 170K on it and not sure of it's history. No issues with shifting...

I am selling my 2005 LJ. it has 154K miles, my daily driver. Upgraded stereo with subwoofer, Blue tooth. 2.5"lift with new wheels and tires 1 year ago. just passed GA emission. MT. clutch, waterpump, alternator, rear main seal have been replaced. ALL records including Window sticker. No rust...

2005 Jeep Wrangler Unlimited – 6 MT - $18.5k Impact Orange (1 of 471 Impact Orange Unlimited in 2005) 112,000 miles NO RUST – Nevada and New Mexico ownership prior to this year Factory Hard Top Bestop NX Soft Top included Upgrades: - Savvy Mid Arm 4 inch lift, installed by Vegas 4x4 in 2018. -...

Bought this bad girl 2 years ago and have had the time of my life with her. I'm moving out of the country in a few months and unfortunately need to part ways. 220000 miles, engine rebuilt at 180000. Rocking 06 Rubicon axles with E-Lockers. Sway bar disconnects, after market fenders and bumpers...

Hello everyone, I was advised to comment on here by another fellow jeeper from another post. I own a 2006 manual transmission rubicon. I bought it about a year ago and I have noticed some noises in the transmission. No heavy mods. It’s mostly stock with a 4 inch lift. Stock driveshafts. I know...

My boss has a 2004 X with the 5 speed manual. There is a very (VERY) slight noise with the engine running and trans in neutral and clutch released. In my infinite wisdom, I suggested to him to not be concerned with it but that I would check to see if the throwout bearing was greasable. So, here...