Is it oil that leaks out of that seal? It smells like slightly burnt oil. It's a very slow leak though, never a drop, just enough to collect dust and grime. Is it difficult to fix? Is it costly?Very possible, very common.
Is it oil that leaks out of that seal? It smells like slightly burnt oil. It's a very slow leak though, never a drop, just enough to collect dust and grime. Is it difficult to fix? Is it costly?
Hmm...yeah, mine is so minor that no oil even gets on the floor where I park the Jeep. I never would have noticed it if I wasn't under there doing a close inspection of my oil skid after beating it to hell on a ledge. Maybe I'll watch close the next few months and see if there's any change.Mine leaked since the day that I bought the Jeep five years ago, and I just lived with it by changing out the cardboard under it every month or so. Just a few months ago I finally decide to have it fixed, and I'll be honest that I didn't do it myself. The $400 it cost me was well worth the time and aggravation saved. I guess it was insurance should against something going wrong like the seal still leaking after the fix (which is known to happen).
Are you talking about the PCV valve?Mine leaks slowly like yours. Has since I bought the jeep years ago. I think mine is also leaking from the back of the valve cover, so I'll be changing that first since it a much easier job than the RMS.
Are you talking about the PCV valve?
Ok, I can see that possibility. I'll take a look too, since I wondered if it was possibly coming from up above.No, but that rear breather tube does spit a little blow by over time. I'm talking about the actual valve cover gasket at the very back of the head. Hard to see with the wiring harness and the bulkhead in the way. They can leak there and the oil will travel down the bell housing mimicking a RMS leak. Or, it could be both.
I talked to an older buddy of mine who had an old Comanche. He said it was more likely the head gasket and to at least start there, and replace with a felpro and go from there. I’ll probably leave it for now and keep all your advice in mind. Thanks!If it is that minor, I wouldn't sweat it. Mine would drip a couple drops after parking it, so minimal I didn't worry. Wasn't until I did a clutch swap that I finally took care of it.
I talked to an older buddy of mine who had an old Comanche. He said it was more likely the head gasket and to at least start there, and replace with a felpro and go from there. I’ll probably leave it for now and keep all your advice in mind. Thanks!
Really? Bobthetj03 thought it was a good possibility. I don’t know much about engines. I’m learning. I guess all I can do is check as best I can, hard to see everything.Head gasket would be my last choice by a long shot.
Really? Bobthetj03 thought it was a good possibility. I don’t know much about engines. I’m learning. I guess all I can do is check as best I can, hard to see everything.
Thanks, I’ll check this morning. I can get OCD about the TJ. Then again, I like working on it and so I’m always looking for an excuse to learn some new procedure and get after it. Lots to give thanks for! Almost Thanksgiving.If it's the valve cover gasket, it should be fairly easy to tell with a flashlight or to just stick your hand on the back of the block and feel for oil. If it's not leaving puddles on the ground, I honestly wouldn't worry about it too much. I left mine for five years, and just monitored the oil level. Never did it leak enough to get to the point that I needed to add oil.