Alatex TJ Enthusiast Supporting Member Joined Apr 4, 2022 Messages 145 Location Texas May 2, 2022 #1 Ok so Savvy shipped 4 new bolts with the arms and they don’t fit the factory holes. Do I need to drill them out or just use the factory bolts?
Ok so Savvy shipped 4 new bolts with the arms and they don’t fit the factory holes. Do I need to drill them out or just use the factory bolts?
rasband Dickhead 🍆 Supporting Member Ride of the Month Winner Joined Sep 11, 2018 Messages 9,071 Location Highlands Ranch, CO May 2, 2022 #2 I had to drill some out, I think the axle side for uppers front and rear.
OP Alatex TJ Enthusiast Supporting Member Joined Apr 4, 2022 Messages 145 Location Texas May 2, 2022 #3 rasband said: I had to drill some out, I think the axle side for uppers front and rear. Click to expand... What type of bit? Carbide?
rasband said: I had to drill some out, I think the axle side for uppers front and rear. Click to expand... What type of bit? Carbide?
MeanGreen86 Buy once, cry once Supporting Member Joined Jul 20, 2020 Messages 543 Location York, PA May 2, 2022 #4 Carbide will work.
rasband Dickhead 🍆 Supporting Member Ride of the Month Winner Joined Sep 11, 2018 Messages 9,071 Location Highlands Ranch, CO May 2, 2022 #5 Alatex said: What type of bit? Carbide? Click to expand... Whatever I had on hand, which wasn't likely anything nice.
Alatex said: What type of bit? Carbide? Click to expand... Whatever I had on hand, which wasn't likely anything nice.