Soft top bow brackets bolt size?

[4BY4ADV]

New TJ owner. Jeep came with hardtop, but I’m trying to piece together a soft top for summer.

Bought a used soft top that was missing the bow brackets. Bought those but they didn’t come with hardware. Anybody know off hand the bolt size/thread pitch?

thanks!
Logan

 

[06TJ35's]

I think this is what your talking about.

Edit: buy the set Chris linked

https://www.quadratec.com/products/11132_9148.htm

 

[Chris]

I think those are the right ones. However, Quadratec is a rip off (as always).

You can get 4 of them here with free shipping for $13.25:

https://www.amazon.com/dp/B0175Y9CSO/?tag=wranglerorg-20

 

[4BY4ADV]

I have those... what I’m looking for are the screws that attach the plate that the bows attach to.

These are what I’m trying to attach.

Omix-ADA 13516.12 Bracket, Soft Top Bow, Right, 1&3, 97-02 TJ

Worse comes to worse I’ll dig through some bags of loose bolts I have and try to find what threads into the roll bar.
Thanks!
Logan

 

[Jerry Bransford]

I have those... what I’m looking for are the screws that attach the plate that the bows attach to.

These are what I’m trying to attach.

Omix-ADA 13516.12 Bracket, Soft Top Bow, Right, 1&3, 97-02 TJ

Worse comes to worse I’ll dig through some bags of loose bolts I have and try to find what threads into the roll bar.
Thanks!
Logan

I think I have what you need up here in Escondido. I'll check to make sure in the morning.

 

[4BY4ADV]

Ah, that would be awesome. I’m just a hop skip and a jump away in Oceanside.

 

[Jerry Bransford]

Well now I'm not so sure. I have the brackets and the bolts were taped to them at one time but they became separated. I think I found them again but I'm not so sure now. I'll take the ones I found out to my Jeep in the morning and see if they fit. If they do they're yours. The Mopar guide says they're M6x1x20 but that seems smaller than what I remember. I'll check tomorrow early as I can.

 

[4BY4ADV]

Sounds good. No rush, I’ll be around north county until early afternoon.

 

[Jerry Bransford]

Ok Logan I've got 'em for you, stop by early afternoon. I'll send you a message with my address. And it turns out that M6x1x20 size is correct but the ones I have are the OEM black finish with the proper head shape. It does require a T-30 torx bit to install.