Recent content by Animatedmean

So after testing and tracing every wire on the jeep with NO change at all pulled 02 sensor and cranked it and jeep started the cats are so clogged it wont run. pulling them off tonight to clean then out and reinstall. Never have i had exhaust so bad it wont start

Do you know the procedure for setting up a new odpa ... i went out and moved this one around some and it was the 1st time it kind of puttered like it was thinking about starting, Its been off i think from the start even in prev posts in here i had. I dont know what the prev owner did so i...

Thanks i will check that out today. I havent pulled the harness but i have kinda looked over it how big of a pain is it to remove

@Wranglerfix thanks for testing my computer and the amazing customer service glad we can rule that out now we know that's not the issue. Not sure where this leaves me looking now

Im sending out my pcm tomorrow to get it checked so no real trouble shooting for a few days ill check harness more over the weekend . yea i think with starting fluid it should have at least tried to start with those numbers

Finally got parts to test fuel pressure 44 key on 50-54?? was bouncing alot during cranking ... when cranking stopped leaked down to 44 ish going to send my PCM to wranglerfix to test

just sent you a email. thank you again

My poor wife has to hear all of my ideas and i was actually telling her this last night as someting need to check ... shes my key turner during all of this so its on the list also

It cranks for days just never starts. yes i would super appreciate it if i could get it tested and rule that out please let me know what you need from me

Thanks for the response the battery is 2 yrs old based on the sticker but im sure its been ran dead several times as i bought the jeep non running . It looks like stock ODPA based on the look compared to the rest of the engine. it had some aftermarket headlights in it i have since removed that's...

I will for sure check it out real good today im at a loss on it so i appreciate any thing to check

I haven't looked that closely at it but i will check it today and make sure

Thanks fingers crossed my last guess is timing after fuel

Yea my 97 has distributor and wires but i pulled the coil ran a rail down the side of the springs and i see spark at every plug ... i even swapped out the coil some results ... the fuel pressure tester kit i ordered needed a diff line to work so waiting on that now but when i had the wrong...

Just did the crank position sensor and no change at all :( waiting for fuel pressure tester to come tomorrow so i can check those numbers after that i guess is pull timing cover and check marks