Recent content by Brenna R.

It does fit through. The PO already had already drilled the bracket out for a 1/2” bolt. The bolt goes through and lines up without the bar.

Not sure if this helps at all

The bolt on the passenger side. I have tried turning the wheel and even made my husband jump on the bumper some more to make sure the axle is as close to centered as I can get

I am at a loss. I have been trying to install the new Currie trac bar but the bolt holes on the axle won’t line up when I get the bar up into the bracket. The bar lines up perfectly with the front but the back is off by like an 1/8th of an inch. It’s almost as if the track bar is cockeyed in the...

Did you figure it out? I’m having the same issue where the bolt won’t line up with the holes

yes that’s exactly it. After slamming it enough times it finally fell out.

Never mind.

@Chris @Lou the piece at the bottom of my track bar frame bracket... is this stock or stuck from my old track bar?

Thank you!

Thank you! Would you recommend going to the stock track bar if I change it?

A few questions. I am fairly positive that my Jeep has a dropped pitman arm. What I am trying to figure out is if the track bar the PO installed requires the dropped pitman arm. The lift is a 5” lift and from reading other threads I can still run a stock pitman. Is 5.5” the max for a stock...