Recent content by Brock

Yeah, I got a picture here but it isn't the clearest. This is the old OPDA and it has the plastic pin from the new OPDA in it to keep it in place. That ended up being the reason why I couldn't pull it out of course. Once removing the pin, the clock ring (?) spun a little bit, but with the pin in...

So I can't seem to delete this thread. The issue turned out to be the alignment pin. It needed to spin as it came out. Putting the new unit in place worked without issue. Everything is good to go.

I'm trying to pull my OPDA out to install the new Crown model. I've achieved TDC, have held it in place with the pin from the new OPDA, but when I try to lift the OPDA out, it rotates counter clockwise, and impacts the engine, preventing it from being fully extracted. I don't understand why it...

Its spliced in. Its one I got from a uhaul. I was in a hurry and just paid them to put it in. I covered the damaged section in electrical tape, but I wonder if the wires are making contact inside of the cable at this point.

So after looking around for something wrong, I found that I had crushed my trailer hitch wiring in the tailgate. There was exposed wiring, so I'm thinking it shorted out something. To be on the safe side, I went and got some new ATM fuses and swapped out the fuse in the glove box, but it still...

Nope. I haven't modified my Jeep. I was just out driving, got in my Jeep to head home, and noted that they didn't work.

Well it doesn't look burned out. According to the fuse diagram, there is spare fuse in the holder. I pulled that spare 10A fuse and put it in the designated slot and it didn't change anything.

I don't have one, but it is looking like I'll have to pick one up.

Yeah, I did some googling and found it. The fuse indicated on the diagram on my glove box is intact.

I have a 2006 Wrangler X. The blinkers and hazard lights stopped working all of a sudden. Everything else in the Jeep works. All of the parking lights come on, the cab and dash dimmer 'switch' works. I have already swapped out the flasher regulator with a Novita LM470. Fuse for the blinkers is...