Recent content by Daniel

I got two small gauge wires with ring connection that only have enough room to connect to the block .. One ground coming from the frame , one single (8gauge I think) splitting off from harness , the red and grey wire clip connection going to the coil, the distributor is connected , the starter...

Ok so I just dropped another 2.5 l in the Jeep , mounted bolted to tranny , then started hooking shit up , power steering ,rad, hoses etc .. Well I'm.not the only one that pulled part s off in prep for the donor motor .. And can't figure out a few hoses and wires .. I know there's at least one...

That was my thought too Chris ,,, now I got a question, will the 2.5l from a 2000 xj mount up to my 98 tj .. Without changing computer , welding new mounts, or changing trans ? I may have a motor I just don't know what's interchangeable... Thanks :)

Deff got it on the cheap .. But now the jeeps sitting dead .. And I can't stop wondering had I not changed motors .. Would I still be driving the Jeep now ..

Ok so a couple weeks ago now .. I had Someone do a motor swap on my tj .. Had a knock in it, burned oil , cracked piston , and just had high miles .. Well my buddy was doing a motor swap on his 93 yj and didn't need it anymore so offered to sell it to me for cheap .. So I jumped on it . had him...

Good morning jeepers, So I'm Pretty sure the actuator pin in my ignition went out.. Which isint a big deal if you like starting your Jeep with screwdriver lol but instead of trying to replace that ,I just want to run a toggle switch but still have to have keep turned on .. Does anyone know...

Love the look of the slider window on the Jeep.. Got mine used a couple months ago.. Only real drawback is they take up a little more space..

Now I talked to someone today about just that, and they told me that it might be that the slave cylinder might not be quite pushing in far enough.. So I was recommended to unbolt the slave and pull the little cap off the rod and add something to it small little button .. Anything that'll fit...

Is that a quadutec part? Lol I just broke mine on the new master cylinder I put in lol stupid me thought it would be smart to clip in to the pedal before putting the pushrod in.. And broke the clip taking it back out..

Looks great ... I'm kicking myself in the ass for not doing the spray liner.. I opted for the paintable .. Thinking no taping less work lol well that backfired ..

OK I don't know what everyone is talking about with the simplicity of this task.. But I have a 98 tj and they were those dam rivit things that the screws were drilled into .. Which when I tried unscrewing the whole thing would just turn and turn.. No plastic clips with screws like in the front...

My problem is 1st and Rev .. Either it slides right in .. Or almost feel like your gonna break the shifter to get it in gear ..