Recent content by Danny Stephens

Could someone tell what the part is called? It’s a piece of rubber between the skid plate and transfer case and mine needs replaced!

Ok thanks Jerry

So do you think I may need to check in to a new trans or what would you recommend Jerry?

I will try that Andy and I have tried double clutching. I will change fluid in transmission and see if that helps.

I am having problems getting my TJ to go into gear but not all the time. I have replaced slave cylinder and throw out bearing. Only thing left is replacing the clutch. Sometimes I can get in it and it goes right into gear smooth as can be and sometimes it just want go into gear at all unless the...

It only squealed for a second but this morning I had the Jeep running and just barely mashed the clutch in and it sounds like it’s grinding so I immediately let off.

I can’t push my clutch in it’s like pushing against a wall. Any ideas what it might be? Right before it went out it started squealing and then it was gone.

Gotcha Jerry thanks!

On this one the top right is covered do you guys think I should rearrange my hoses that are connected?

It does only choke down and completely cuts of with my finger on it.

Could someone please tell me what hooks up right here? I know something does because it has vacuum. When I put my finger over it she chokes down!

Ok thanks

I’m losing oil pressure and can’t figure out why! I figure if I’m gonna replace the engine might as well go bigger. Think it’s a bad idea? Think I should rebuild the 4 banger? What you think?

thinking of going to 4.0 from 2.5! Can anyone point in the direction to start and what I need to start looking for? Thanks!