Gollywomper
TJ Addict 45 From Corning CA
Latest activity Postings Attachments Images About
-
-
Gollywomper replied to the thread Leaking thermostat housing (What am I doing wrong?).All of the crap in The recess has to come out. It could be causing the thermostat to stick out, this not allowing the housing to fully... -
-
Gollywomper replied to the thread Leaking thermostat housing (What am I doing wrong?).Did you try using a bit of RTV on the bolt threads?
-
Gollywomper replied to the thread NP231 doubler / crawlbox.$2500 for a set of 3-1 gears for a 205 is dumb.
-
i think i saw midnight's post about it.....................i think they also said it was 2500$...... so screw that.
-
Gollywomper replied to the thread 2 ducks today.I dunno, but I heard the Toyota guys started passing dildos around.
-
Gollywomper replied to the thread Go to for 4 lift springs.Just about any spring will work. However if you plan to run longer travel shocks then go with a spring like Currie that has a long...
-
5 step DIY on how to get 25 posts quick: 1.Start a thread on Metalcoak duroflex joints, in it say that Savvy wait times are outrageous...
-
Gollywomper replied to the thread Front tire wear / steering help.There should be zero movement in your track bar. Can’t believe that is not causing some drivability issues.
-
Gollywomper reacted to Tob's post in the thread Has anyone considered a Ford Ecoboost swap in a TJ? with
Like.
Note on comparing fuel efficiencies for prospective swaps: Fuel efficiency has very little to do with weight, other than possibly... -
Gollywomper replied to the thread Can't get upper control arm hole to realign with bolt.Put your jack stands under the frame. Then use the floor jack to raise or lower the axle until the hole lines up.
-
Gollywomper reacted to txbemis69's post in the thread Has anyone considered a Ford Ecoboost swap in a TJ? with Like.
i have the 3.5 in my f-150 and it’s scary fast for a full size truck. keep your foot out of it and mine will do 21-22 mpg in town. i...
-
Gollywomper replied to the thread Solo wheeling vs clubs.I guess I’m lucky. The club I belong to is full of good folks. Generally a small club with a few rigs per run. Except the big fundraiser...
-
I don't get wheeling solo. Half (most?) of the reason I enjoyed wheeling so much was because of the people and friends I got to wheel...
-
Gollywomper replied to the thread Poor braking.How long has it been since you replaced the brakes? Did you go through the manufacturer’s pad break in process?
-
Gollywomper replied to the thread Poor braking.Did you break in the new pads?
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
