JKP's latest activity
-
JKP replied to the thread Misfire after rev limiter.Remove the oil cap, look straight down at the head with the engine hot. It usually cracks and leaks there. You can also sample the... -
-
JKP replied to the thread Misfire after rev limiter.The coolant use is probably a cracked head on your 01. Wide open throttle will expose a weak coil. Just go out and accelerate hard...
-
JKP replied to the thread TJ with acceleration issues after sitting 3 years.A tapping sound on the passenger side can be the cam sensor, or possibly a stuck lifter.
-
JKP replied to the thread TJ with acceleration issues after sitting 3 years.Go to your profile and fill in the info under About:
-
-
JKP replied to the thread TJ with acceleration issues after sitting 3 years.Also, fill in your Jeep's info.
-
JKP replied to the thread TJ won't start and I've tried everything.Fuel pressure? Also, a stuck IAC will cause this. Slightly depress the gas pedal while cranking and see if it starts. If so, IAC is...
-
JKP replied to the thread Radiator overflow coolant bottle losing inches per day.A/C clicking is low refrigerant. Check for coolant coming out of AC drain or in passenger floor. If so, leaking heater core.
-
JKP replied to the thread Rubicon locker question.Here's how it works: One push, the cluster logic requests the rear axle to lock. Rear light blinks until the state of the rear axle...
-
JKP replied to the thread Rubicon locker question.You can't test it that way. The rear wheels on the ground prevent the front wheels from turning in 4WD. You'll have to put all 4...
-
JKP replied to the thread Trying to get this Jeep running after sitting for 14 years.No experience with the 2.5, but I would check the FSM under Resources here to be sure the Haynes manual was correct.
-
JKP replied to the thread Rubicon locker question.Is the front actually locking when the compressor cuts off and you have done some turns?
-
JKP replied to the thread Rubicon locker question.The factory setup turns on the rear locker on the first push, then turns on the front locker with the second push.
-
JKP replied to the thread Checked past posts on fan speed.Most likely the blower resistor pack. If not that, bad switch.
