Recent content by 01TJ-Blues

I added 1.5” flat bar to mine then gussets to make sure it was stout. Enjoy the ribs!

I was thinking slotting the holes that mount to the tailgate, much easier to do. I modified my stock carrier heavily to support the 35 on headlocks so I know the addition of flat at would work. It’s just how much effort you want to put into it. I do not personally like the spaced out spare...

It sounds like you are barely off from clearing your bumper so why not simply oval your stock mount holes 1/4 inch and adjusting it up a hair? You could also take the stock mount to a fab shop and have them weld 1” flat bar to the bottom and top below where the existing holes are and...

“All” as defined in two of you that are focused on the wrong part of the description?

I already said that, the washboard is where it was noticed, which was probably due to the continuous repeated quick spring cycle.

The Currie bump stops hold the springs in place, they may not “lock” them but they do prevent them from falling out in the event of an over extension. I also stated that my shocks prevent the springs from extending past unseating. The springs also have wear marks on the cut spring end where...

Not arguing physics, I stated I was playing BEFORE the washboard and after, on the washboard was when the noise was apparent. Very well could have popped out somehow PRIOR to the washboard, which was stated in the original post.

It was for sure in the spring stop, it hasn’t been an issue for 4 years. I was in some flexing before the washboard road but that’s when the racket began.

Reviving this one. I have the Currie setup which uses the bump stop to lock the spring in place and also my shocks are appropriate for the droop. That said, I was out playing around and when I hit the washboard road after I had a clunk noise coming from the front. Got home, searched high and...

Freezing it did not work for me and after fighting it for hours, ruining two seals I decided a “special tool” was needed. I built this brace so that it holds center on the drain pan edges and carries the load of the c-clamp on the bolts. Dandy PVC nipple ground to fit the seal attached to a...

Lightly used Genright Matrix tail lights with OE plugs installed. These are in good shape and have no issues. $185 shipped to the lower 48.

I’ve done some searching and cannot seem to find this easily but if one has the Black Magic Big Brake kit what is required to make the Yukon hub kit fit? I recall some had to have some machine work done but I can’t recall exactly what it was. Any help is appreciated.

Double carden front driveshaft, rebuilt completely about 1,500 miles ago and has zero damage or issues. Has 1310 ujoints at the attachment points and in the carden. This is setup for a 4” lift on a TJ. Extended length is 39”, collapsed is 35 5/8”. Asking $175 buyer pays shipping. Only reason...

Just thought these might come in handy to folks on the forum.

What is the collapsed eye to eye and the extended eye to eye?