Painfultruth's latest activity
-
Painfultruth reacted to freedom_in_4low's post in the thread Differential Fell Out of Housing with
Like.
I'll see your diff falling out and raise you with bearing races falling off the carrier. The Dana 35 in my Sahara I'm pretty sure had been... -
The first time I opened my Dana 30 to install a lunchbox locker I had the same thing happen. It didn't appear anyone had ever been in to it...
-
Why a new driveshaft? That CV joint can be rebuilt for a lot cheaper. When I started hearing those "angry sparrows" I took the...
-
Painfultruth replied to the thread Stalling issue.If the cam and crank sensors have been replaced and the wiring, connections particularly the grounds are solid, unplug the O2’s to...
-
Painfultruth replied to the thread Stalling issue.Unplug the O2 sensors and then test drive it. You may also need to check the OPDA timing.
-
good idea. I don’t have a scanner so I’ll order it up and hopefully get to the bottom of this that way. Thank you.
-
Painfultruth replied to the thread Stalling issue.Need to get some live data and/or freeze frame data.
-
@deadbeat son Lares on the way..new not reman....you do hoses at the same time?
-
That's all fine and dandy until you're the one. Sadly, we've been the "one" more times than is tolerable for any reman steering gear...
-
Painfultruth reacted to JohnsGunsmithing's post in the thread Where should I mount my hi-lift jack? with Like.
just like a good hand cannon,. its better to have it and not need it, then to need it and not have it. in 40 years runnin trails, ive...
-
Painfultruth replied to the thread Steering gearbox replacement.Redheads are remans some are good some not so much, Lares has new direct replacements with a lifetime warranty.
-
Painfultruth reacted to AndyG's post in the thread Calling all Camber and Caster Gurus: Help! with Like.
Your caster numbers indicate possible axle bind as well- (cross caster is built in to stock design) and it is possible your axle was...
-
Painfultruth reacted to zachpeakee's post in the thread Calling all Camber and Caster Gurus: Help! with Like.
Clarify THIS statement. What type of shop did you take it to? I ask because most typical alignment shops are not equipped with the...
-
Painfultruth replied to the thread Calling all Camber and Caster Gurus: Help!.Caster is considerably off
-
the same spots exist on the front. Measure your front pinion angle using those spots. From there, your caster is separated by ~12°...