SACressionnie
New Member 38 From Bailey, NC
Latest activity Postings About
-
-
SACressionnie replied to the thread Transmission bell-housing oil drip.I read that there is an opening at the top of the bell housing on 4.0L Wranglers. I can't see this opening. Just did my RMS and took my...
-
SACressionnie replied to the thread Rear Main Seal Replacement (4.0).So, I completed the RMS replacement. Did everything by the book and took great care with the install. Been driving for a day or two and...
-
SACressionnie replied to the thread Rear Main Seal Replacement (4.0).Awesome. Thank you for putting this together. Getting started tonight.
-
SACressionnie replied to the thread Pinion Nut Slightly Over Torqued.Yeah, ordered new nut and sleeve. Installing tomorrow.
-
SACressionnie replied to the thread Pinion Nut Slightly Over Torqued.Yeah, that's what I was thinking. Already ordered new nut, sleeve, and seal.
-
SACressionnie replied to the thread Pinion Nut Slightly Over Torqued.No, I used a wrench with breaker. Bumps was the best way to describe the action.
-
SACressionnie replied to the thread Pinion Nut Slightly Over Torqued.Agreed. Ordered new sleeve, nut, and seal. Do it over again. Thanks for the input. I am going to check the rotational force again when I...
-
SACressionnie replied to the thread Pinion Nut Slightly Over Torqued.That's what my buddy said. It's also very cold outside. I'm wondering if that is making it more difficult to turn. 9 in lbs isn't much...
-
So, I'm rebuilding my Dana 35 rear end and I just installed new pinion bearings. Put the pinion nut on and started tightening to set the...
-
-
Loading…
-
Loading…
