Recent content by sahara.v1

It absolutely is. No roll cage, spins in all 4 gears and maxes out at about 120kmh

Thanks man! That my friend is our homebuilt 1980s CBR 500r go-kart.

Built and installed my switch panel today. Im so happy with the turnout. Just used a 90° piece of aluminum and made some mounts to the dash sorry for the massive images. I couldn't figure out how to make em smaller.

Hit an SUV today. Jeep did nothing but slide on the wet city pavement. Only damage I had was a broken fog light lol

(y)

finally finished my tailgate table today! Cost me about 50 bucks, what do yall think?

Replaced my old smittybilt grab handles with Warn handles Also added a Warn fire extinguisher mount

Using two Y adapters to connect to a 4 channel amp is completely fine and wouldn't cause any issues expect for one, if you count it as one. Diverting the 2 channels into 4 will take away your ability to fade your speakers which is changing the volume between the front and rear pairs. I also had...

Thats exactly what I did

This is what the tweeter mount looked like I used a hole saw to cut a hole the sam size are the bottom part of the mount. After crimping and dropping the wires through I filed just enough off the edges of the hole that I could just barely force the threads in. I was gonna fasten it with a...

Its not currently in the jeep as im wrapping it but I believe it was .50 cubic feet that was required for a closed box in the spec sheet. I'll have it facing down so I have more room for my camping gear

I assume you're talking about the mounting of the tweeters? The speaker set came with a few different tweeter mounts mounts and I chose to use this one. It has a little pivot point so I can angle it wherever I chose and is flush mounted. I hole cut just a tiny bit smaller than the mount and...

When I purchased my Tj I dropped 1k (this is cad) into a new system. I use a cheap Sony DSX A415BT head unit to power to sets of JBL 9 series 5.25" component speakers which are now discontinued. ( i bought the last 2 off Amazon.ca ) the filters are sitting loosely in the speaker cavities...

It looks like the stock bumper cut to be stubby but I think its been made with portion of C-frame because is much thicker

Thanks!