Recent content by ShaneMK

Hey y’all, I think I finally got the pattern looking good, tell me what y’all think. I’m going to decrease backlash just a little because as of right now it’s 7-10 tho and I would like to close that up to 5-7 just to give some break in tolerance.

Yeah that’s what I was thinking, and everything I’ve read about being too deep in the root means I need to remove a few tho in pinion shim, but when I do that I get that spread out pattern and that also seems to be bad. And yes every adjustment I do to the pinion shims I adjust backlash...

Well the reason I was worried about the last pattern I showed was it has a real sharp edge on the bottom. Maybe I’m misreading it but I’d rather take it out a few times than messing it up. Posting a better pic of that “sharp” bottom edge on the marking Its centered up in the gear nice but just...

Hey sorry took me a few to send the last message. Yeah I think I added somewhere around 10-15 tho and I was able to get it centered but it looks like it’s biting too deep in that ring gear. Yes the oil slinger is also a shim. I’m not sure if there is an adjustment I can make to get that pattern...

But I ran into something very interesting, not exactly sure how it helped, but I ended up adding a few shims (can’t remember the exact numbers, I have to pull it out again soon so I’ll measure then). I added a few shims behind the pinion race and it centered the pattern on the ring gear but it’s...

This was the pattern with no shims behind the inner pinion race, I still have the oil slinger one (not the stock one but the one that came with the kit, it was about half the thickness).

My process has been pull everything out carefully. Unbolt the carrier and set it down, then unbolt the pinion and set it down then remove the inner pinion race, change the shims. Then put the pinion back in and put the nut back on and tighten it until I get 20 in/lbs of preload. (I did over...

Yes I’ve adjusted backlash every time I’ve changed pinion depth. Originally there was no shims behind the pinion race.

Any help or advice would help a lot.

So I’ve pulled everything 4 times since my last message and removed shims every time. I’ve ended up with no shims behind the pinion race and I have a similar heel/toe pattern pictured in #2, but now it’s contacting more of the crown of the ring gear and appears to be too shallow. Any opinions...

Yeah absolutely, I haven’t started to put my rear back together at all, but this is my 6th attempt on the front, taking it back out now going to pull a few tho hopefully that’ll get it right where I want it.

Yeah that’s what it was looking like to me, I’ll pull some more off the pinion. And yes I am using set up bearings so any adjustments that I need to make can be made quickly. About to start on it again today, ill update when I get some pinion shims pulled and try and get that pattern in the...

From what I understand this means I have to decrease the pinion depth shim, is this correct? This is the contact pattern interpreter I’ve been using.

Hey y’all, I just got finished working on my Jeep today and I have a few questions. I’ve tried to get the gear marking right a few times and I can’t seem to get it right, I was real close but it was slightly too deep so I pulled a shim from behind the pinion race and put in one that was just a...

I read up a little about the locker and it is different then a lot of others probably still suffers from the same problem as normal lunchbox lockers. But yeah it has some pretty neat extras that fix a few issues with the normal lunchbox.