Recent content by ThomasB3003

After a little over two years of owning my TJ, today I sadly sold her.

Okay, Thank you. Spent hours looking through different websites till I remembered I had the forums to turn to.😂

So, I have owned my jeep for a little over two years. Has 89,000 miles on it. My u joints are going out, and I can't find a difference between the front and rear ones. All of them need to be replaced. I just can't find a place that says which is which. Any help?

okay thank you

So, I have owned my jeep for a little over two years. Has 89,000 miles on it. My u joints are going out, and I can't find a difference between the front and rear ones. All of them need to be replaced. I just can't find a place that says which is which. Any help?

Thank you so much for those part numbers. I have been looking for them for a a better part of an hour.

Well... I found out that my passenger side upper control arm is bent. Any suggestions on what type of control arms to put on? I’m putting a lift in it in about 6 months, have to pay it off first.

If you are doing any off roaring, I’d advise getting a winch. A lot of people say you need a lift to go off goading but a stock Jeep is very capable of this. After the winch, I’d do tires and a lift at the same time.

The reason I replaced all the parts was because I had death wobble. A few of the ball joints were really loose and had too much play. When I replaced all of them, I took my Jeep and had an alignment and my tires rotated.

So I think my right upper control arm is bad. When I press the break, I hear a knocking noise from the right side. Also, around 50 mph I have slight steering vibrations. A little while ago I replaced the sway bar links, track bar, tie rods, and a steering dampener. Any suggestions on how to...