Recent content by TJUNLIMITED211

I’ll check that and swap the crank sensor. Thanks Jerry.

Thanks Chris. That’s my next move. I saw your write up on it I’ll reference it. Good lookin out.

Yes it’s spot on

Recently went with 5.13 gears. 33” ko2s. Was hoping for much better performance to tame the deep OD but I’ve noticed it still kicks in at 40mph with a light pedal and neuters this pig down to 1200rpm. When I gas it to power through the drop the rev limiter activates at 3200rpm way below red...

I’ll do it. Thanks.

Well... I screwed this up. Used the jack as directed but I guess I concentrated underneath the tub more than getting a tight fit on the slider/base portion. Pretty frustrated don’t really know how I’m gonna fix this .

Got it and understand what you’re talking about now. Appreciate it.

Sweet. I’m on it

Great suggestion. That was also my thinking. I want them as tight as possible.

Very helpful I’ll do just that! Great looking sliders looking fwrd to mine going on thank you.

This is all great stuff and addresses the issues I’ve been having. I’m going to go back at it tomorrow I’ll let you know how it goes (or if I have any other questions) I know jcr customer service is top notch I’ve got their f/r bumpers. Big reason I went with them again so I was kinda bummed...

Dude... THANK YOU. Cleared up exactly what I was confused about. Really appreciate the heads up on the nutsert pushing the base out I’ll do what u recommended. On that note: did you remove the 3 factory nutserts that held the front rocker fender fairing on? Right behind the front fender? If so...

Does anyone have experience installing these? Not understanding/trusting the instructions re: nutsert placement and application. 1.) instructions call for nutsert placement in 6th (last) hole of base plate but seems like it should be in the 5th behind the base of the seatbelt mount area. 2.)...

Thanks anyway for checking. I’ll look around

Awesome. Thanks