Recent content by UK STUBBS

Colne Lancashire uk just washed it

This is what we buy in the uk it’s basically a cut and re welded stabiliser bolt which gives a better angle for clearance please bare in mind this one needs spinning a bit to line up better.hope this helps.

Thanks guys I will send it back. can you for-see problems if I use a lhd as I’m struggling finding an alternative Rhd pitman.

I’ve found some numbers 7812145 on the steering box which after google says it’s a gm box does anyone know of a compatible standard pitman arm I could use or should the standard jeep ones fit ? Thanks.mark

I’m sure your right the output spline is 1.215” I think the crown one is manufactured too small.i will crack the nut on my 06 tj pitman tomorrow and check for sure the spline measurements that way I can order a Rhd mopar arm and fingers crossed it will fit.looking at the dropped xj one I took...

Ha ha I get it now brilliant I’ll be using that now down the pub

Thanks I will have a think and maybe a ring round the breakers yard before I go down the lad route.mrblaine said it was a wag box does that mean from a wagoneer?thanks again.mark

That’s what I’m thinking but the only Rhd ones I can find are from crown and when I look at other pics of the crown ones they all look the same

The difference below. Thanks

My 06 and the 03 look and measure the same on the output shaft but the crown one I ordered is the same part number as my 06 but I can’t see how it will fit on as it’s 3mm smaller in between the splines as pictures if some one has spare that they could measure between the splines for me that...

What does wag mean is it a box that’s been swapped from something else or is it the make of steering box that came with the jeep?im going to measure the output shaft on my 2006 to this 2003 today if they are the same maybe I’ve been sent a wrong standard pitman with a smaller splined hole...

I think your correct MrBlaine I’ve noticed the splines are not at right angles to the pitman,ive found the part number from the dropped pitman arm says it’s for an xj so I’m thinking po has swapped the steering box out for an xj box I’m wondering if the original right hand drive steering box had...

I can’t find anything either for the steering box part number or the pitman arm part number I can’t understand my self why lhd and Rhd tj pitman shave different part numbers but the dropped one I have taken off is a bigger bore.

I’m wondering if po swapped the tj box with an xj one as the dropped pitman arm says xj at the end of the part number if so can I get a normal drop xj pitman to fit or do they not do them? Thanks

Hi I’ve just spent most of the day taking off a dropped pitman arm to replace with a standard one.when I tried to put the replacement crown one on found it to be a lot smaller on the splines. it said in the add 1997-2006 so I presumed they were all the same I’ve attached some pictures and any...