What did you do to your TJ today?

Finally…

ORO Swayloc 👍
UCF bumper w/winch plate 👍
Savvy winch guard 👍
Badlands Apex 12000lb winch 👍
Wizard Recovery Gear rope, thimble & Hawse fairlead
Billet aluminum Recovery points 👍

Done…

ISIMG-1072051.jpeg


ISIMG-1073913.jpeg
 
  • Like
Reactions: Hog, chudlet, Duner and 12 others
  • Like
Reactions: CMBD, Kiwi TJ and 97JadeTJ
Installed the heated-seat rocker switches to replace the switches provided by PRP.

I was overzealous with the wiring cleanup...removed a necessary ground to my locker switches. All good now after moving the ground point to the fuse box.

Screen Shot 2024-04-11 at 3.05.10 PM.png


Replaced the Joying 8.8" with a Sony 7". The replacement bezel arrived banged up so I'm waiting on the replacement.

Screen Shot 2024-04-11 at 3.00.58 PM.png
 
Last edited:
  • Like
Reactions: LakeBeard, Hog, Duner and 10 others
Danarch said:
Did you just screw it to the bezel? If so do you think it will be strong enough to support the tablet?
Click to expand...

I put a 1/8" aluminum backing plate on the inside of the bezel. I did the same for the 3-cell MagLite that is mounted to the bottom of the bezel - it's a lot heavier than the tablet and hasn't given me any problems in 4 years, so I'm reasonably certain that the tablet mount will do just as well.
 
  • Like
Reactions: matkal and Danarch
Neal said:
I put a 1/8" aluminum backing plate on the inside of the bezel. I did the same for the 3-cell MagLite that is mounted to the bottom of the bezel - it's a lot heavier than the tablet and hasn't given me any problems in 4 years, so I'm reasonably certain that the tablet mount will do just as well.
Click to expand...
That is exactly what I was wondering, if you put a backing plate on the inside. Thank you for responding.
 
Top Bottom
Back