Wildman's TJ is getting a face lift
- Thread starter Wildman
- Start date
Gunnersmate
TJ Enthusiast
Damn that was close I almost went down the rabbit hole
Gunnersmate
TJ Enthusiast
The Conversation turned to drinking and I told My Preacher damn I am Glad I don't Drink any less My Preacher is like don't you mean anymore cause he said I don't drink at all I looked him square in the eyes and said You mean you dont drink Ever?????. so when you wake up in the morning thats the best your gonna feel all day.
OP
Tires are back on and it's ready to roll outside. But we're having a windy day with gusts around 40 MPH so I'm going to wait until tomorrow.
Gunnersmate
TJ Enthusiast
OP
Not yet, woke up sick this morning so haven't worked on it.
Gunnersmate
TJ Enthusiast
OP
OP
Took advantage of some younger people to help push the Jeep out of the garage.
Tomorrow hopefully I'll feel better and I can get started on the disassembly of the engine.
Tomorrow hopefully I'll feel better and I can get started on the disassembly of the engine.
Gunnersmate
TJ Enthusiast
I did get my Belt Fed Pez dispenser out today, may go to the range tomorrow let it run a little and then go set up for some hog hunting this weekend, see if can't ventilate some of them turds in bulk.
Gunnersmate
TJ Enthusiast
Gunnersmate
TJ Enthusiast
The Pez Dispenser
And Yes the both the Jeep and the Can Am will have a mount because this is Merica
The Costco Sniper Rifle for when really really really you need to ventilate something in bulk
And Yes the both the Jeep and the Can Am will have a mount because this is Merica
The Costco Sniper Rifle for when really really really you need to ventilate something in bulk
Last edited:
Gunnersmate
TJ Enthusiast
And then there is 338 Lapua for when you need to revoke birth certificates in another zip code
Gunnersmate
TJ Enthusiast
Wildman this thread is freaking Epic 508 pages , over 10000 replies and nearly 3/4 million views
OP
<div style="width:100%;height:0;padding-bottom:100%;position:relative;"><iframe src="https://giphy.com/embed/LWpu6LRS4hr7hI4gSc" width="100%" height="100%" style="position:absolute" frameBorder="0" class="giphy-embed" allowFullScreen></iframe></div><p><a href="
">via GIPHY</a></p>
OP
Going on the engine stand.
Disassembling in progress.
Main caps are next. Pulled the front apart and took the timing chain off too. Which means I'll have to time the cam again when I reassemble it.
Only thing left to remove are the rod caps and I'll have the crankshaft out. Then I'll slowly start reassembly of the engine after I clean everything up.
I'll post pictures of the bearings once I get it all apart.
Disassembling in progress.
Main caps are next. Pulled the front apart and took the timing chain off too. Which means I'll have to time the cam again when I reassemble it.
Only thing left to remove are the rod caps and I'll have the crankshaft out. Then I'll slowly start reassembly of the engine after I clean everything up.
I'll post pictures of the bearings once I get it all apart.