I pulled out my 32RH to inspect for a shifting issue… didn’t really find anything… the clutches looked good I could still read the writing on them…
put it back in and started the jeep back up…
When I put it into drive I can hear the trans making noise and it doesn’t move on the ground… it did move the wheel on jackstands before I let it down…
It does have reverse and when I shift into low it moves forward….
I was reading about the kickdown band possibly… but I’m pretty sure I adjusted it properly before putting everything back together…
I filled the torque converter prior to install and added about 4 maybe 5 quarters of fluid after putting it all back together with a new filter and lock up solenoid….
I checked the dip stick and it seems to be right at the full mark… I checked it with the engine running in neutral after warmed up….
Any ideas would be greatly appreciated.
put it back in and started the jeep back up…
When I put it into drive I can hear the trans making noise and it doesn’t move on the ground… it did move the wheel on jackstands before I let it down…
It does have reverse and when I shift into low it moves forward….
I was reading about the kickdown band possibly… but I’m pretty sure I adjusted it properly before putting everything back together…
I filled the torque converter prior to install and added about 4 maybe 5 quarters of fluid after putting it all back together with a new filter and lock up solenoid….
I checked the dip stick and it seems to be right at the full mark… I checked it with the engine running in neutral after warmed up….
Any ideas would be greatly appreciated.