231J transfer shifter wont go to 2WD, stuck in neutral
- Thread starter myjeep3
- Start date
Like Mac said, it's hard to tell from a picture at that angle. Need to remove front driveshaft and shoot pictures more straight on to see it well enough.
On mine, as near as I can see with the DS and skid in place:
4-Lo = lever is to the rear, almost touching the housing, about 5:15 or 5:30
N = lever is straight down, about 6:00
4-Hi = lever is slightly toward the front, about 6:30 or 6:45
2-Hi = lever is more toward the front, about 7:30
On mine, as near as I can see with the DS and skid in place:
4-Lo = lever is to the rear, almost touching the housing, about 5:15 or 5:30
N = lever is straight down, about 6:00
4-Hi = lever is slightly toward the front, about 6:30 or 6:45
2-Hi = lever is more toward the front, about 7:30
Then I guess am stock in 2wd. Moving past 4hi is extremely hard, dont even think its fully engine in 4hi, because when shifter handle inside the jeep is at 4hi, it drops down to 2wd position if i dont hold it up. Also hearing gear noise if I try to force it past the 4hi position.
The linkage under the jeep could cause all this mess? I hope that all it needs and not a tcase.
The linkage under the jeep could cause all this mess? I hope that all it needs and not a tcase.
Here are more images I just too. The savvy cable arrive, I am getting ready to install.
What do you think of the tcase lever position, is it in 2wd? Cant move farther up. One of the image is a view from under the hole of the skid plate.
What do you think of the tcase lever position, is it in 2wd? Cant move farther up. One of the image is a view from under the hole of the skid plate.
I was referring to the shifter at the tcase. I have the cable installed, but the lever in the jeep won't reach 4H, and goes back down.
Similar threads
