Would using this cam bolts negate the need for adjustable upper control arms?

Kerry

Kerry

Member
Joined
Jun 27, 2019
Messages
75
Location
New Zealand
I was sent in error an AC Delco 45M1095 cam bolt, which as the leaflet shows in the attached photo is for the rear upper control arms. (I was actually after front cam bolt kit, which I now have)

So having a look at it, it sure looks like it will fit in the rear of my 05 TJ, and there are indentations for the cam washers to turn against, so I am wondering if using these would negate the need for adjustable upper control arms, somewhat at least?
Has anyone tried them?

20200327_134658.jpg


Cam bolt.png
 
I researched this some years back and turned up some recommendations against using them in the rear based on a tendency to self - loosen. So I got arms and never looked back.
 
I didn’t use cam bolts, I knocked out the slots in the control arm mounts on the rear axel and rolled it back until I got the angle I wanted, then tack welded the OEM washers in place. Worked like a charm
 
If you want to do it right, you need adjustable control arms all around, even with only 2" of lift.

Most people don't do it at such a low lift height, and you can get away with it obviously. However, if you want to do it right, you want adjustable control arms.
 
  • Like
Reactions: Mumblewood
But, then, will it get you enough angle? Will you still need cams got the rear lowers too, to get the proper angle? I would say, if you're getting minor vibes, sure, otherwise adjustable control arms.
 
someguysjeep said:
do you have a reason to need to install them?
Click to expand...
I have a 3.25" lift, and although its riding and handling fine I was intending on getting adjustable arms at some point. I would never have thought of this if it had not turned up in my mail box and became curious is all...
 
Kerry said:
I have a 3.25" lift, and although its riding and handling fine I was intending on getting adjustable arms at some point. I would never have thought of this if it had not turned up in my mail box and became curious is all...
Click to expand...

unless they are required to fix an existing issue then it's just a waste of your time. and if they are crap as Jerry mentions, it's reason enough to loose them.
if things function well together as is, there is no need for adjustable CA's.

if things function well now don't mess with them.....if you have plans to change things then the need can come up, but until then it's just $ for nothin. if your prepping for a big change your best bet is to pile parts and tackle big changes all at 1x.
 
Top Bottom
Back