Funky Replacement Steering Knuckle

Matthias13

Matthias13

Member
Joined
Jan 20, 2019
Messages
25
Location
Northern Arizona
I'm redoing my steering and unfortunately have to replace the knuckles to do it. I ordered a pair of Crown Automotive replacements and a couple of the holes seem to be drilled off center?

I've never paid close enough attention to the OEM knuckles but I'd think the TRE hole for the steering would be centered? Did I end up with a defect?

20210317_172446.jpg


20210317_172510.jpg
 
  • Haha
Reactions: toximus
Blaine would know easily. Maybe he will see your post. If there’s a reason or a drawback he will know.
 
Matthias13 said:
Fingers crossed lol. The hole on the bottom looks off centered too but guess I wont know until I attempt the install
Click to expand...
The relationship between the hub mounting surface and the ball joint holes is the priority.
Set the hub face on a flat surface and measure up to each ball joint hole. Then compare it to your OE knuckle.
 
Top Bottom
Back