bell housing

  1. W

    Input shaft not aligning to pilot bearing

    Hey, guys, my input shaft isn't going into the pilot bearing on my '98. 4.0, 5-speed, clutch is lined up it's just that the input shaft will not line up to the bearing. I used the clutch alignment tool, splines are on the transmission shaft. Pictured below is how much I have left to go before...
  2. F

    Bell housing & rear main questions

    Tracing a lower engine knocking/ticking and checking the tightness of the bolts on what I believe is the bell housing? The bottom right bolt upon trying to tighten just continuously spins instead of getting tighter. It is in place and not freely moving around but it is not snug at all and...
  3. S

    Torque Spec Bellhousing to NV3550 transmission

    I have looked at so many charts of what the righr specs might be, but have no defined answer. Does anyone know the right torque spec for the bell housing to transmission and to the block. My bolts are 1/2 heads.
  4. S

    WTB: AX15/NV3550 Bellhousing

    My BellHousing Cracked. I Live in the Lehigh Valley Area of PA. I have a nv3550 transmission.
    • Shame-Ranger
    • Thread
    • ax15 bell housinf bell housing bellhousing lehigh valley manual nv3550 pennsylvania transmission
    • Replies: 0
    • Forum: Wanted
Top Bottom