crankshaft

  1. W

    Input shaft not aligning to pilot bearing

    Hey, guys, my input shaft isn't going into the pilot bearing on my '98. 4.0, 5-speed, clutch is lined up it's just that the input shaft will not line up to the bearing. I used the clutch alignment tool, splines are on the transmission shaft. Pictured below is how much I have left to go before...
  2. Mar

    Bad Crankshaft Sensor

    Got everything up and running finally after a long winter. Went for a drive in the morning and everything was running smoothly. Then in the afternoon went for a drive and within 1 mile started stalling (I have a 2002 Wrangler X 6cyl automatic). I was able to shut down and restart, but kept...
  3. Chris

    Jeep Wrangler TJ Crankshaft Position Sensor Replacement

    There are several reason why you would need to replace your Jeep TJ Wrangler's Crankshaft Position Sensor (or CPS for short) with the most obvious one being that your 'check engine' light has illuminated and a quick check with an OBDII reader indicates you have thrown one of the following MIL...
  4. Kris11

    Stuttering / Stalling Problem

    Hey Guys, I was just wondering if anyone had the same problem as me. For about a month now my jeep has been stuttering and stalling at random times while I drive it. I brought it in to the stealership 3 times and they charged me 130$ in total for getting their techs to look at it for an hour or...