nut

I recently bought a 2000 TJ that had one bolt and some terrible welds holding each of the stabilizer bar retainers to the frame. I’m ready to reattach the stabilizer bar and looking for input on the best way to bolt the retainers to the frame. I had to remove the welded nuts on the inside of the...

So, I'm rebuilding my Dana 35 rear end and I just installed new pinion bearings. Put the pinion nut on and started tightening to set the crush sleeve. I got super close to the low end of the spec (15 in. Lbs) on the rotational force and decided to go another bump or two (not with impact). Now...

2004 Jeep Wrangler Rubicon 5.3 :cool: I had to replace the hinges on the glass liftgate, and in doing so, I needed to remove the washer motor to complete the task. There is a nut that is attached externally to the shaft coming through the glass that the wiper arm then attaches to. That nut...