Front drive shaft vibration after re-gear

[toximus]

Any manual hubs that work with the BMB BBK?

That's what I did. Call BMB... you'll need a different saddle and rotor.

You'll also need to figure out what you want to do for shafts. Iirc there was some talk about the Yukon shafts not being good? I went with RCV which unfortunately you need an entire new kit if you're already running RCV since the stub and ball are different than the TJ kits.

 

[Sh4rkattk]

That's what I did. Call BMB... you'll need a different saddle and rotor.

You'll also need to figure out what you want to do for shafts. Iirc there was some talk about the Yukon shafts not being good? I went with RCV which unfortunately you need an entire new kit if you're already running RCV since the stub and ball are different than the TJ kits.

Running ten factory chromoly with 5-760X joints. I think I should be good.