Front driveshaft rebuild balancing question

ejay

TJ Addict
Original poster
Joined
Dec 29, 2019
Messages
2,124
Location
CA to WY refugee
The Spicer rebuild kits are back in stock at Dennys DriveShafts and I was thinking about saving some money and rebuilding mine on my own. I've had the rear done already at a local shop who mostly outsourced to a driveshaft shop.

Question is, when I rebuild, do I need to have it re-balanced?
 
The Spicer rebuild kits are back in stock at Dennys DriveShafts and I was thinking about saving some money and rebuilding mine on my own. I've had the rear done already at a local shop who mostly outsourced to a driveshaft shop.

Question is, when I rebuild, do I need to have it re-balanced?
Just joints? Should be all good. Only get it rebalanced if you have some vibes or notice a bad difference after.
 
For good measure, I mark all the yokes and the centering yoke so everything is oriented the same after the rebuild to avoid introducing vibes.
That's good thinking.
 
For good measure, I mark all the yokes and the centering yoke so everything is oriented the same after the rebuild to avoid introducing vibes.
Believe it or not that was on my to do. I did that when I removed it years ago while trying to track down a chirp that ended up being the rear shaft needle bearings.
 
Up here in the great northern rustbelt the DS is often so rusted and pitted that it looks like the surface of the moon. Rebuilding has often caused vibes as the balance weight(s) have gone missing many miles ago. I don't know why they don't start a vibe then, but frequently will after you rebuild it. Just be aware the problem may show up. And be ready to need a re-balance of the DS.
 
  • Like
Reactions: ejay