I can get the gaps even and things mostly lined up but there's not an obvious way to adjust for the door sticking out at the bottom but not the top. I can pull the striker farther in, but then it'll just pull the top of the door in past the outside of the tub.
It's present at front and rear, but front isn't as bad.
I've got new delrin hinge liners delivering tomorrow, and there is some slack in that bottom hinge that I can see when the door is open and I have the entire door as leverage, but I can't move the pin around to close this gap when the door is closed so I haven't talked myself into that being the fix yet.
It's present at front and rear, but front isn't as bad.
I've got new delrin hinge liners delivering tomorrow, and there is some slack in that bottom hinge that I can see when the door is open and I have the entire door as leverage, but I can't move the pin around to close this gap when the door is closed so I haven't talked myself into that being the fix yet.