Harness connector retainers
- Thread starter B1Toad
- Start date
definitely a bastard electrical connector clip, question has come up for them in the past. potentially this https://www.mouser.com/ProductDetail/Aptiv-formerly-Delphi/13580939?qs=W19cWFaYmR/85CgEPtY%2Bfg== but im not positive its exactly the item you need.
drawing of item if you'd like to compare.
https://productdata.aptiv.com/api/assetstorage/2949_f156ba40-992e-497d-8574-6aa3d6d3f342
drawing of item if you'd like to compare.
https://productdata.aptiv.com/api/assetstorage/2949_f156ba40-992e-497d-8574-6aa3d6d3f342
Last edited:
LONGJP2
TJ Expert
I like those but the studs are too big to fit the holes in the Jeep, I think I'll try making something.
In case someone comes along looking for a solution it was a pretty easy fix, I just trimmed the heads down on some regular round headed push fasteners so they were a tight fit and I forced them into the connector groove, they're holding good. While I was at it I installed a battery terminal protector after reading about it here a few days ago, then I put it up on my "lift" and heated up my exhaust pipe with O/A right after the collector
and pushed it over 1" as somehow it was off and stretching the hangers and rattling against my receiver hitch. By Friday I should be low enough on gas to drop the tank and replace the pump and regulator, then the ARB pump arrives Sunday. Mexico fishing trip is only a week away!
and pushed it over 1" as somehow it was off and stretching the hangers and rattling against my receiver hitch. By Friday I should be low enough on gas to drop the tank and replace the pump and regulator, then the ARB pump arrives Sunday. Mexico fishing trip is only a week away!