Hello everyone,
I need some help. I've searched and can't find any mention of the problem I am having with my install. 2006 Wrangler LJ Rubicon. Everything is ok with the exception of the studs for the disconnects at the ends of the cable. On the shift lever end there is a bunch of slop between the stud and the lever with it tightened. It's like the stepped bushing is too small in diameter and also too tall. The transfer case end is similar but not nearly as bad. My wrangler only has 73k so I don't think that the holes in the levers are worn. The studs aren't long enough for a extra washer, which I'm not sure would help. Thoughts?
Thanks in advance, Scheu
I need some help. I've searched and can't find any mention of the problem I am having with my install. 2006 Wrangler LJ Rubicon. Everything is ok with the exception of the studs for the disconnects at the ends of the cable. On the shift lever end there is a bunch of slop between the stud and the lever with it tightened. It's like the stepped bushing is too small in diameter and also too tall. The transfer case end is similar but not nearly as bad. My wrangler only has 73k so I don't think that the holes in the levers are worn. The studs aren't long enough for a extra washer, which I'm not sure would help. Thoughts?
Thanks in advance, Scheu
Last edited: