Latest activity Postings Attachments Images About

• • 

    jjvw replied to the thread Barnes 4x4 Low Profile Bumper.

    In my case, the only time I'm dragging the spare tire is going into a very steep climb out dropping off of a tall steep ledge. These are...

    4 minutes ago
  • 

    jjvw replied to the thread Metalcloak slimcrawler rear bumper.

    If you aren't dragging the bumper, is won't matter that Metalcloak can't design a decent bumper, especially with the lip hanging down...

    17 minutes ago
  • 

    jjvw replied to the thread Barnes 4x4 Low Profile Bumper.

    You build for what you want the Jeep to do. Mine needs a minimal bumper and it needs corners for reasons beyond the lack of bumper...

    25 minutes ago
  • 

    jjvw replied to the thread Barnes 4x4 Low Profile Bumper.

    Without receiver https://nextventuremotorsports.com/products/tjlj-ultra-high-clearance-rear-bumper With receiver...

    Today at 5:36 AM
  • 

    jjvw replied to the thread 35s with 4.56 gears.

    4.88 minimum

    Today at 4:29 AM
  • 

    jjvw replied to the thread Barnes 4x4 Low Profile Bumper.

    RS is making the same mistake as Barnes and Genright by not enclosing the rear crossmember. Next venture and Swag are the better options.

    Today at 3:28 AM
  • 

    jjvw replied to the thread 35s with 4.56 gears.

    As would I. 4.88 is still slightly under geared.

    Today at 3:23 AM
  • 

    jjvw reacted to machoheadgames's post in the thread 35s with 4.56 gears with Like.

    I’d go 5.13.

    Today at 3:22 AM
  • 

    jjvw reacted to primetime4's post in the thread Heavy duty tie rod help with Like.

    I’m afraid to see what the frame on this looks like. Hope you didn’t pay too much. I would take that into consideration before dropping...

    Yesterday at 11:51 AM
  • 

    jjvw replied to the thread Heavy duty tie rod help.

    See post #2. You bought a poorly designed inverse T steering kit. Other than the obvious problem of ruining the wheel, this steering...

    Yesterday at 11:20 AM
  • 

    jjvw replied to the thread Heavy duty tie rod help.

    Looks like it needs at least one brake pad and a new caliper piston.

    Yesterday at 10:49 AM
  • 

    jjvw replied to the thread Heavy duty tie rod help.

    Did the heavy duty upgraded steering ruin the wheel while you drove around?

    Yesterday at 10:29 AM
  • 

    jjvw replied to the thread Heavy duty tie rod help.

    Go back to factory style inverse Y. That will correct this problem and others you don't know you have created yet.

    Yesterday at 10:19 AM
  • 

    jjvw replied to the thread Which Steering Stabilizer?.

    If it still dampens, stay with OEM. My understanding is that it was pretty heavy, which is a good thing.

    Yesterday at 7:56 AM
  • 

    jjvw reacted to mrblaine's post in the thread Daily Driver, Go Where I Want To Build with Like.

    When you find one that looks like it belongs under the hood of a vehicle, post it up because so far, I have not found anything I like...

    Yesterday at 6:27 AM

  Show older items
• Loading…
• Loading…
• Loading…
• Loading…