I always hear about issues with such and such brand fenders, blah blah blah, but never saw anything definitive.
I bought them on eBay $280 shipped for the pair. I believe the Mopar version is over $800 each.
They have some issues including the edges of all the metal are extremely sharp and cut up my hands.
Here is the overall installed view. The tire is to keep the hood down for fitment. I couldn't reuse my old latches because the nuts were too rusted.
Another view
Both the fenders lean down to the outside. Maybe I can pull them up hard to straighten (and probbably cut myself on the razor metal edges)
There is a weird gap above the plastic fender flares on both sides. Pass worse than driver. Maybe body filler in this little area?
Further away view
This is probably the biggest issue. The driver side is not flat. It bows outward at the rear of the wheel well.
Where is bows outward
Hole misaligned for vacuum canister. Maybe drill another hole and utilize the left side of the bracket?
Again, where it is bowed out. Maybe a 2x4 and sledge hammer can put it back into place?
The smaller gap at the front flare on the driver side.
Missing screw holes for washer bottle.
Crappy pinch/bending/stamping process
This part was cut on the pass. side but not the driver side and scrapes the tub part. Will need to be cut.
Just wanted to post so others know what to expect. I would love to hear others experiences. I sent a message to the seller since they guarantee fit and quality. Waiting for a response, I think I may need at least a new driver side because of that bow in the side.
I bought them on eBay $280 shipped for the pair. I believe the Mopar version is over $800 each.
They have some issues including the edges of all the metal are extremely sharp and cut up my hands.
Here is the overall installed view. The tire is to keep the hood down for fitment. I couldn't reuse my old latches because the nuts were too rusted.
Another view
Both the fenders lean down to the outside. Maybe I can pull them up hard to straighten (and probbably cut myself on the razor metal edges)
There is a weird gap above the plastic fender flares on both sides. Pass worse than driver. Maybe body filler in this little area?
Further away view
This is probably the biggest issue. The driver side is not flat. It bows outward at the rear of the wheel well.
Where is bows outward
Hole misaligned for vacuum canister. Maybe drill another hole and utilize the left side of the bracket?
Again, where it is bowed out. Maybe a 2x4 and sledge hammer can put it back into place?
The smaller gap at the front flare on the driver side.
Missing screw holes for washer bottle.
Crappy pinch/bending/stamping process
This part was cut on the pass. side but not the driver side and scrapes the tub part. Will need to be cut.
Just wanted to post so others know what to expect. I would love to hear others experiences. I sent a message to the seller since they guarantee fit and quality. Waiting for a response, I think I may need at least a new driver side because of that bow in the side.
Last edited: