Had the Jeep since 2008, and of course went through many renditions to end up at this point. Purchased with a Skyjacker 2.5" lift, then had a few RC lifts, before biting the bullet and going with a Clayton lift.
Most recently did the Currie 44 front, and Yukon Super 8.8 conversion in the rear, allowing me to run 37's. Yes I know 37's eat up components, but why not enjoy the ride and the overall look! I was able to get 2 years out of my front hubs wheeling very very hard with the 37's bolted up.
Build List:
4" Long Arm 3-4 Link Clayton Lift
Clayton Full Skids
Super 8.8 Rear with Detroit Locker
Currie 44 Front with Grizzly Locker & RCV's
4.56 Gears
37x12.50x17 Milestar Patagonias
Adams Driveshafts F/R 1350 UJoints
Raceline Beadlocks with spare mounted in back
Currie Antirock
Currie/Savvy Steering
PSC Big Bore Box/Pump
Black Magic Brakes Steering Cooler
Custom UCF front bumper
Warn Zeon 10-S Winch
Savvy Rear bumper
Savvy Tank Skid
Savvy Rocker Armor
Custom Cowl Wrapped Amor
JCR Fold Down Tailgate
Trucklite Headlines
Savvy Tails
Custom Cage tied into frame in 4 spots
Wake Board Speakers mounted to cage with wiring inside of tubing
Corbeau Heated Seats
PRP Harnesses
Next Up:
Install the PSC Ram (on the shelf)
Artec Rear Coil Correction Brackets (in the mail)
New Hubs & Tune Up Kit
Atlas Transfer Case