Finally about ready to put axle back on, about two months later than planned. I can't afford to waste any more time or have any more fuckups. Is this the best way to bolt it back on?
1) Position axle on motorcycle lift/jack under front end
2) Position springs on their respective seats (I forgot to mark which one was one which side )
3) Raise jack a little
4) Attach upper control arms
5) Attach track bar
6) Attach lower control arms
7) Attach shocks
8) Attach steering linkage
9) Put wheels back on
10) Gently lower so that the wheels are bearing weight
11) Torque down control arms and anything else loose
11) Reattach front driveshaft
Somewhere in there, I still need to refill the front pumpkin with gear oil. Is this a sound procedure or should I change the order at all? Sorry to reask this, I can't find my post on one of the FB groups about it.
1) Position axle on motorcycle lift/jack under front end
2) Position springs on their respective seats (I forgot to mark which one was one which side )
3) Raise jack a little
4) Attach upper control arms
5) Attach track bar
6) Attach lower control arms
7) Attach shocks
8) Attach steering linkage
9) Put wheels back on
10) Gently lower so that the wheels are bearing weight
11) Torque down control arms and anything else loose
11) Reattach front driveshaft
Somewhere in there, I still need to refill the front pumpkin with gear oil. Is this a sound procedure or should I change the order at all? Sorry to reask this, I can't find my post on one of the FB groups about it.