Rear axle sitting more to the right

[RL_MJ]

Installed new 4in lift and rear track bar has a relocation bracket I installed , fo some reason once the rear was all done and on the ground I noticed the wheels on the rear were offset , and bump stops were a slanted a lot towards the rear ? Any suggestions
Note ; has tub off and hasn’t moved at all

 

[Armytruck6x6]

As weight is applied it will cause the axle to shift over to the drivers side. Wait till tub is on etc... as far as the bump stops, send pics.

 

[RL_MJ]

As weight is applied it will cause the axle to shift over to the drivers side. Wait till tub is on etc... as far as the bump stops, send pics.

 

[Rob5589]

Did you adjust the control arms? There will be some coil "bend" at that lift height. Adjusting the arms will alleviate some of it.

 

[Armytruck6x6]

Thats normal after lifting, especially if you adjusted pinion angle... only way to fix that is to relocate upper and lower spring perch. Lower may hit shocks and the track bar may hit the fuel tank skid plate. You can cut a notch in the lowers so they dont hit the shocks and you can knock in the corner of the skid plate so the track bar doesnt contact it.