So I finally got my new rear lower control arms (Core 4x4 Tier 1) to replace my worn out stock ones. Adjusted them to 16", I have a 3.25 inch lift. Drivers side lower went in with no problem. Pulled out the passenger side lower and left it overnight. this evening I went to install it and it was way off, I figured it moved some over night. I had to crank it up off the ground several inches from the back of the axle at the shock mount to get it lined up. after lowering it down the passenger side is about 1.5 inches lower than the drivers. If I drive it will it settle down? TIA